Algae Control in Spas & Hot Tubs

Algae can be a problem for any sanitation system, it grows very quickly once it gets a hold and colours the water green.

The potential for algae bloom can be removed from a spa by removing the algaes primary food source - phosphates. Without its main nutrient the potential for algae growth is significantly reduced. 

Where do phosphates come from?

Unfortunately phosphates can be present in the tap water in quite high quantities in some areas of the UK because the water authorities add them to reduce the amount of lead leaching into the water from old pipe work.  Phosphates also come from leaves falling into your tub and bather wastes such as sweat and urine. Other phosphates sources are detergents, some insecticides, fertilisers, soft drinks, toothpaste and even some pool and spa chemicals.

How do I remove algae from my tub?

If algae does ever get a hold in your hot tub then the best solution is to first remove the the food, using a phosphate remover, and then to shock the water with a sodium based shock treatment, such as SpaLite, to kill the algae.  You should then thoroughly clean your filters using a proprietary filter cleaner, such as FilterBrite, and immediately re-apply your chosen sanitize. 

Assuming that the correct santiser level is maintained, the problem shouldn't reoccur until the next time you change your water.

Note: As an alternative to using SpaLite, you could also kill the algae by super-chlorinating the water to 20 ppm of free chlorine, but you must wait for the chlorine level to reduce to a safe level before bathing again.

ALGAE CONTROL PRODUCTS

1. AquaTrend Phosphate Test

The AquaTrend Phosphate kit includes 50 powder pillows, two testing vials and a reference card with directions. The test gives accurate results after only 60-seconds, and measures phosphate from 0 to 1000 parts per billion.

50 tests per bottle

£ 

2. Lo-Chlor Starver Phosphate Remover

Lo-Chlor Starver is a liquid phospahte remover that will take all dissolved phosphates out of spa or swimming pool water. Adjust the pH to within the range 7.2 - 7.6 before use.

2.5 litres

Contains: Lanthanum Carbonate complex.  Non-toxic and biodegradable.

£ 

3. AquaSPArkle Spa Fusion

AquaSPArkle Spa Fusion is a fast reacting shock treatment for rapid water recovery, destruction of non-filterable wastes and enhanced water clarity.

Apply whilst pumps are running and leave cover off for 1 hour following use. One sachet treats up to 1500 litres (330 gals). Contains water clarifiers.

Active components: Di-Chloro Isocyanurate Di-Hydrate, Sodium Persulphate and Clarifiers.

  per sachet

5 or more sachets @   per sachet

12 or more sachets @   per sachet

4. AquaSPArkle Immerse

AquaSPArkle Immerse is a top quality powdered filter cleaner that removes oils, grease, rust and, particularly, scale from hot tub filter cartridges.

Immerse is a rapidly soluble formula that may be used in a Filter Soak Container or the dishwasher. Use one sachet per 18 litres of water, ensure that the cartridge is completely immersed and soak overnight. Alternatively, use half a sachet in your dishwasher.

For best results allow cartridge to dry before re-installing.

Contains: Sodium Hydroxide and Sodium Metasilicate. 100g sachet.

  per sachet

5 or more sachets @   per sachet

12 or more sachets @   per sachet