Aquasparkle Spa pH plus
What
is AquaSPArkle pH Plus?
AquaSPArkle pH Plus is a granular product used to adjust water pH
upwards.
What is pH?
pH is a measure of the acidity or alkalinity of
your water. The pH scale has a range of 0 – 14, with 7.0
being neutral. Water with a pH below 7.0 is acidic and
above 7.0 is alkaline.
A number of factors can affect
the pH of your spa water, such as dilution with fresh water,
introduction of air, chemicals and bathers, so it is important
that it is checked on a regular basis.
Why should you balance the pH of your spa water?
Hot tub water with very low pH (acidic water) can
cause corrosion of your equipment and staining on the tub
surfaces. It can also be very unpleasant to bath in.
In addition many sanitisers do not perform
efficiently if the pH of the water is not maintained within a
specified range.
What is the optimum level of pH in hot tub water?
A number of factors can affect the
pH of your spa water, such as dilution with fresh water,
introduction of air, chemicals and bathers, so it is important
that it is checked on a regular basis.
| Sanitiser |
Recommended pH range |
|
Active Oxygen |
7.0 - 7.4 |
|
Aquafinesse |
7.0 - 7.8 |
|
Chlorine |
7.2 - 7.6 |
|
Bromine |
7.2 - 7.6 |
|
PristineBlue |
7.0 - 7.4 |
The pH level should be maintained within the
ranges shown in the table.
Directions for Use:
For best results pre-dissolve the product in a
small plastic container filled with spa water and stir well to
ensure that the product is fully dissolved.
-
Add 10g (or approximately
2 teaspoons) of granular product to litre of warm spa
water.
-
Carefully add the resulting solution to the
spa whilst the pumps are turned on.
-
Re-test water after 30
minutes.)
-
If pH is still low repeat
the oprocess until the desired pH is established.
Compatible with chlorine, bromine and biguanide
sanitisers.
AquaSPArkle pH Plus Contains:
Sodium Carbonate 1 Kg
£
