Hot Tub Cover Lifters

HOT TUB COVER LIFTERS - UNDER MOUNT

 

View our Spa Cover Lifter Comparison Table

 

 

 

Cover Valet Cover Rock-It Under Mount

The Cover Rock-It Understyle fits most spas up to 96" wide.

The Cover Rock-It is well constructed of the highest quality materials and powder coated aluminium. It installs easily in minutes and is an very affordable solution from Cover Valet in the USA. 

This cover lifter is identical to the Cover Rock-It Side Mount except that includes additional plates to allow the lifter to be supported by the weight of the spa, rather than attaching to the skirt.

Stores the cover at ground level.

Cover Rock-It Installation Instructions 

£ 

---

Leisure Concepts CoverMate II - Under Mount

The Covermate II is a good choice of cover lift when clearance behind the spa is not important (18"/46cm clearance is needed).  The cover is stored low down but off the ground.

This version of the CoverMate II requires no holes or attachment to the spa. The special mounting brackets slide under and are held in place by the weight of the spa.

Made of black powder-coated aluminum with screw caps, bolt covers and rubber grips to ensure years of trouble-free performance.

Fits most spas up to 96" (2.4m) wide.

£ 

CoverMate II Installation Instructions

---

EASYLIFT 2

This cover lifter is British made from 100% light weight aluminium so it won't rust.  It features 3mm wall thickness tubing which gives a strong, rigid construction. [Check out any cheaper brands carefully because they're very likely to be only 1.5mm wall thickness, providing poor rigidity and little protection from bending in strong winds or when using with larger spa covers.]

Nylon powder coated for extra toughness and supplied with high tensile bolts to fix  to the ground.  Each coverlifter comes with comprehensive fixing instructions and appropriate size drill bit. All you have to do is supply the tools!

The EasyLift 2 is a simple fulcrum assisted lifter, great for providing a less restricted view when in the open position with the added benefit of being foot operated, if required. It's fixed in place by a plate slipped under the hot tub skirt, although the plate can rotated through 180 degrees and bolt to the floor if it is not possible to secure it under the skirt.

Suitable for all square or oblong tubs up to 8 ft (2.45m) wide.

The EasyLift 2 keep the cover clear of the ground so that it doesn't get dirty or scratched.

Rear clearance required: thickness of the folded cover approximately 18” (440mm)

Side clearance required: 4" (100mm)

EasyLift 2 Installation Instructions

£